JavaScript is disabled. Because that a much better experience, please allow JavaScript in her browser before proceeding.

You are watching: 2013 ford focus blower motor resistor location


So whereby is the blower engine resistor located on the 2015 Escape? i pulled the gloves box out and didn"t watch it there.
*

Welcome to the forum.Need to know if you"ve gained the hand-operated or automatic climate manage system to be specific we"re ~ above the exact same page. Referencing the Workshop hands-on ....On the manual system there"s a component labeled "Blower engine Resistor" under a 4-pin connector plugged into the driver"s next of the HVAC plenum just below the motor itself (about 7 o"clock place relative to the motor). FWIW the WSM calls for removal the the accelerator pedal to R&R the component.On the automatic mechanism there"s no ingredient labeled as "Blower engine Resistor" however instead a "Blower Motor control Module" in the exact same location and also other blower control components elsewhere.Hope the helps.
FORMER Owner
the "14 escape SE 2.0 FWD (66 mos/58k essentially trouble-free miles, to be a great car to me)
*

Note edit to above post - ns misread the "front the vehicle" arrowhead when I an initial looked at the schematic ar diagram; error revealed once I checked the component r&r section.
FORMER Owner that "14 to escape SE 2.0 FWD (66 mos/58k essentially trouble-free miles, was a good car to me)
Thanks, somehow ns missed this yesterday! i do have actually the hand-operated climate control and also was may be to see where the resistor is. Not certain if it will be cheaper to carry out myself as soon as I add in the chiropractor bill with the contortions that will be required to get it out! ns don"t watch why the pedal would should come out, looks prefer it is just one screw and a molex plug. I have the right to feel the one screw holding the in place however it is simply out of see so that have to be fun.
*

Look at the panel spanning the next of the console - under the squarish snap-in sheathe is a retaining screw - eliminate that and also you"ll have the ability to pry ago that panel for maybe much better access.Hint: as soon as you article a concern use thread devices to i ordered it to the thread for this reason you"ll get notice of replies
*

FORMER Owner
of "14 escape SE 2.0 FWD (66 mos/58k basically trouble-free miles, was a great car come me)
*

Thanks, somehow ns missed this yesterday! i do have the hand-operated climate control and was may be to watch where the resistor is. Not sure if it will certainly be cheaper to carry out myself once I add in the chiropractor bill v the contortions that will be compelled to acquire it out! i don"t check out why the pedal would have to come out, looks choose it is simply one screw and also a molex plug. I deserve to feel the one screw holding the in place yet it is just out of view so that must be fun.

See more: Why Are The Sepals And Petals Referred To As Accessory Parts "


I"m just around to try this on mine 2016 escape SE,. Im not looking front to it. Many thanks Ford. Another"Better idea" eh?
*
Continue through Google
On Ford escape Forum uncover news, discussions, service tips, & technical help for her 2013+ Escape.
3G Electronics, Audio, and Lighting3G Engine and Technical DiscussionFord Escape general Discussion3G Exterior and Interior3G Wheels, Tires, Brakes, and also Suspension