*
Chrysler 4.0L engine

*
Make sure the oil filter comes v a gasket!
Get your motor oil. The warranty needs 10W-30 the meets Chrysler MS-6395. This Chrysler spec will be post on the back of the bottle. Most oil brands satisfy this requirement. A notable exception is Mobil oil. I believe this is because of lack of gaining the spec native Chrysler much more than no being compliant. If your engine is tho on warranty, make sure you usage the exactly stuff. This is no a high performance engine. Conventional oil is an excellent enough; the engine virtually always outlasts the remainder of the vehicle!Get her oil filter. I typically use Purolater PureOne filters. Have a save associate watch the the exactly model. Note: Make certain that there is a gasket ~ above the filter!Warm the engine. Journey it a couple miles therefore the oil is nice and also hot.Park the valve on a level surface. Before shutting off the engine, turn the steering wheel every the means to the appropriate to ease accessibility to the oil drain bolt.From the passenger side, lay on the soil in front of the tire. Looking up you have to see the oil pan.

You are watching: 2010 town and country oil capacity

*
View indigenous passenger-side.
*
Oil drainpipe bolt o left. Oil filter ~ above right.
Place oil capture pan under the bolt.Loosen the oil drainpipe plug by turning counter-clockwise making use of a 13-mm socket and wrench. I typically grab mine torque wrench simply due to the fact that the added length boosts the torque i can apply to the bolt.Once the loose, gradually turn while keeping pressure ~ above the bolt for this reason the warm oil stays in the engine"s oil pan. Once you deserve to tell its prepared to come out, conveniently remove the bolt. The oil will be hot! Also, don"t drop the bolt right into the oil pan. That no fun fishing it the end of warm motor oil.Pop open up the hood. The hood release is top top the dash near the driver"s left knee.Unscrew counter-clockwise the engine"s oil cap. That is easily figured out with a snapshot of an oil can and 10W-30 printed on it. Removed this lid will increase the speed at which the hot oil exit the engine. Make sure oil is still draining into the capture pan and not overshooting it!Wait until the oil merely drips the end of the oil pan.Move the oil record pan so that can get oil from the drain bolt hole and also the oil filter.Put a cap-style oil filter onto her wrench.
*
Cap-style oil filter remover top top wrench.
Place the cap onto the oil filter. Revolve counter-clockwise to remove. When its fully removed, it will certainly dump warm oil. Make certain your catch pan is inserted accordingly.Make certain the old oil filter still has actually the gasket attached to it. If its no there, it can be grounding to the engine. Remove it! If girlfriend don"t, girlfriend will have actually a significant oil leak later! ns have adjusted oil for 25 years and this van to be the very first that ever had the gasket stick to it. The was quickly removed after i wasted about 4 quarts of oil.Wait for all oil to drip from the engine. This will certainly take roughly 20 minutes.Screw the bolt earlier into the engine block through hand. Use your socket and also wrench to more tighen it. Perform not over-tighten! use a torque wrench to be sure. Note: The oil bolt includes a gasket. See the diagrams below:
*
Correct placement of gasket on oil bolt.

See more: What Does The So And Ns So Rings Sons Of Anarchy, So/Ns Ring (Jax Teller'S Rings)

*
Incorrect placement of gasket ~ above oil bolt.This needs pushed down right into the seat.
Using your finger, smear oil ~ above the oil filter gasket. This will certainly ensure a an excellent seal.Put the oil filter ~ above the oil filter tower as tight as you deserve to using her hands. You might use a torque wrench come make sure its on tight enough. Generally, I simply make it as tight by hand as possible.Place a funnel into the oil filler location in the engine compartment.Add 5.5 quarts that oil.Put oil filler cap back in place.Fire increase the engine and also make certain the oil press light walk out. If that doesn"t, shut turn off the engine immediately. Something is wrong. Consult a vehicle guy!If there are any leaks, tighten the bolt or filter.This Chrysler engine is odd. The takes mine whole evening for all the oil to drain into the oil pan. Do a precursory examine now come make certain its in ~ spec on the dipstick. Add if necessary. Inspect a second time in the morning!
Posted byBP Wrightat1:20 PM
*