Fuses defend your vehicle’s electric system native overloading. If electrical parts in your vehicle are not working, the device may have been overloaded and blown a fuse. Before you change or repair any kind of electrical parts, inspect the proper fuses.
You are watching: 1999 ford ranger 4x4 relay location
The complying with charts tell friend which fuses safeguard each electrical component of your vehicle. If a fuse blows, all the components of your vehicle that use that circuit will not work.
Once girlfriend have established which fuses to check, follow the steps under Checking and Replacing Fuses further down this page.
Passenger Compartment Fuse Panel
No. | AMPS | Circuits protected |
1 | 7.5 | Power winter Switch |
2 | 7.5 | Blower engine Relay, PAD Module, air Bag Diagnostic Monitor |
3 | 7.5 | Left Stop/Turn Trailer Tow Connector |
4 | 10 | Left Headlamp |
5 | 10 | 1998-1999: Data attach Connector (DLC) |
6 | 15 | 2000: Overdrive, Back-up Lamps, DRL, 4×4 |
7 | 7.5 | Right Stop/Turn Trailer Tow Connector |
8 | 10 | Right Headlamp, Fog desk lamp Relay |
9 | 7.5 | Brake Pedal position Switch |
10 | 7.5 | Speed manage Servo/Amplifier Assembly, Generic electronic Module (GEM), change Lock Actuator, mix Door Actuator, A/C-Heater Assembly, rotate Signals |
11 | 7.5 | Instrument Cluster, Daytime running Lights (DRL), RABS Resistor |
12 | — | Not Used |
13 | 20 | Brake Pedal place Switch |
14 | 20 | Rear Anti-Lock Brake system (RABS) Module |
10 | 4 Wheel Anti-Lock Brake device (4WABS) Module, 4WABS main Relay | |
15 | 7.5 | Air Bag Indicator Lamp, Alternator Indicator Lamp, instrument Cluster |
16 | 30 | Windshield Wiper Motor, Wiper Hi-Lo Relay, Wiper Run/Park Relay |
17 | 25 | Cigar Lighter, Data connect Connector (DLC; 2000) |
18 | 15 | Driver’s Unlock Relay, All-Unlock Relay, All-Lock Relay |
19 | 25 | PCM power Diode, Ignition, PATS |
20 | 7.5 | RAP Module, Generic digital Module (GEM), Radio |
21 | 15 | Flasher (Hazard) |
22 | 20 | Auxiliary power Socket |
23 | — | Not Used |
24 | 7.5 | Clutch Pedal position (CPP) switch, Starter Interrupt Relay, Anti-Theft |
25 | 7.5 | 1998-1999: Generic digital Module (GEM), instrument Cluster |
26 | 10 | Battery Saver Relay, Electronic transition Relay, internal Lamp Relay, Power home window Relay, Electronic change Control Module, Dome/Map Lamp, GEM, Instrument swarm (2000) |
27 | 15 | 1998-1999: Electric Shift, backup Lamps, Daytime to run Lamps (DRL), Transmission regulate Switch, Pulse Vacuum Hub Lock |
28 | 7.5 | Generic electronic Module (GEM), Radio |
29 | 15 | Radio |
30 | 10 | 1999-2000: RABS test Connector |
15 | 1998: Park Lamp/Trailer Tow Relay | |
31 | — | Not Used |
32 | — | Not Used |
33 | 15 | Headlamps, Daytime running Lamps (DRL) Module, instrument Cluster |
34 | — | Not Used |
35 | 15 | 1999: Park Lamp/Trailer Tow Relay |
10 | 1998: RABS check Connector | |
36 | — | Not Used |
Power distribution Box
The power circulation box is located in the engine compartment on the drivers side near the fender.
No. | AMPS | Circuits protected |
1 | 50 | I/P Fuse Panel |
2 | 40 | Blower engine Relay |
3 | 50 | 4 Wheel Anti-Lock Brake mechanism (4WABS) Module |
4 | 20 | Power Windows |
5 | 50 | Ignition Switch, Starter Relay |
1 | 10 | A/C Relay |
2 | 20 | Auxiliary strength Point |
3 | 20 | Electronic change Relay and also Electronic transition Control Module |
4 | 20 | 2000: Fog Lamp and also Daytime running Lamps |
15 | 1998-1999: Fog Lamp and also Daytime running Lamps | |
5 | 15 | 2000: Trailer Tow Park Lamps |
10 | 1998: air Bag Diagnostic Monitor | |
6 | 10 | Powertrain regulate Module |
7 | 30 | 4 Wheel Anti-lock Brake device (4WABS) Module |
8 | 30 | PCM Relay |
9 | 20 | Fuel Pump Relay and RAP Module |
10 | 15 | Horn Relay |
11 | 15 | Parklamps Relay and Main light Switch |
12 | 30 | Mam irradiate Switch and also Multifunction Switch |
13 | 15 | Heated Oxygen Sensor, EGR Vacuum Regulator, EVR Solenoid, Camshaft position Sensor (CMP), Canister Vent Solenoid |
14 | 30 | Alternator Voltage Regulator |
15 | — | Not Used |
1 | Wiper Park Relay | |
2 | A/C Relay | |
3 | Wiper Hi/Lo Relay | |
4 | PCM power Relay | |
5 | Fuel Pump Relay | |
6 | Starter Relay | |
7 | Horn Relay | |
8 | 1999-2000: Fog Lamp manage Relay1998: Washer Pump Relay | |
9 | Blower motor Relay | |
10 | 1999-2000: Foglamp Isolation Relay1998: Foglamp Relay | |
11 | Not Used | |
12 | Not Used | |
13 | Park Lamp/Trailer Tow Relay | |
14 | Washer Pump Relay | |
1 | RABS Resistor | |
1 | RABS Diode | |
2 | Electronic Engine Controls Diode |
Checking and also Replacing Fuses
If you need to examine a fuse, follow these steps:
1. Discover the fuse panel, i m sorry is located in the left finish of the instrument panel. The power circulation box (described previously in this section) is discovered in the engine compartment, mounted on a bracket attached come the vehicle drivers side fender apron.
To access the fuse panel, eliminate the fuse dashboard cover by inserting her finger in the divot and also pulling on the cover. The underside of the cover has four spare fuses. A fuse pulling tool is located in the lower right corner of the fuse panel in case you have to replace a swollen fuse.
Color Coded: The preventive fuses because that your auto are color coded together follows:
10 amp — red15 amp — light blue20 amp — natural30 amp — irradiate green.See further down ~ above this web page for examples
2. ~ above the fuse dashboard cover, uncover the number of the fuse you desire to check. The chart on the cover tells you where tolocate the fuse ~ above the panel.
3. Check the fuse to watch if it is blown. Look v the clear side of the fuse to view if the metal wire inside is separated. If it is, the fuse is blown and also should it is in replaced.

Another method for experimentation fuses is to use a Bussmann fuse tester. There’s no need to remove the fuse native the holder. Girlfriend simply readjust the prong width on the tester to heat up with the bare metal spots top top the finish of the fuse, and then watch for the indicator light to glow signaling the the fuse is good.


4. Replace the fuse through one that has the right amperage rating
*WARNING always replace a fuse v one that has actually the mentioned amperage rating. Using a fuse v a greater amperage rating can cause severe wire damage and also could begin a fire.
5. Placed the fuse dashboard cover ago on.
Even after you change a fuse, that will proceed to punch if you execute not uncover what led to the overload. If the fuse proceeds to blow, have actually your electrical system checked.
See more: Which Family Of Elements Loses Electrons Most Easily ? What Elements Easily Give Electrons
Fuse color / Ratings:
As pointed out above, fuses are color coded to their AMP rating. View the image below for examples.