How to carry out a Fuel Filter readjust on a Chevrolet SilveradoThings You"ll Need:Cold beverage*>Container for fuel*>2-ton+ Jack*>Jack was standing or ramps*>Open-end Wrench*>Pressure gauge*>Shop towels*>New fuel filter*>Changing the fuel filter ~ above a Chevy Silverado is not much different that an altering the oil on many Chevy van models. Follow these how-to accuse to change fuel filter ~ above chevy silverado and also browse other short articles to discover all around how to change the fuel filter on chevy silverado through our arsenal of cost-free tutorials and silverado truck discussion.The fuel filter is typically located along the frame rail of the vehicle. On part trucks it may have actually been relocated come the engine compartment. On GM van the filter is usually located on the inside of the driver"s side structure rail around halfway back. When in doubt, trace a fuel heat from the engine backwards or native the tank forward in bespeak to situate the filter. Most trucks use a spin-on fuel filter situated on the framework rail. This filter deserve to be turn counterclockwise after the fuel press is relieved.When to change the Fuel FilterA clean fuel filter in your Chevy Silverado truck means clean fuel injectors and a clean fuel pressure regulator. Changing the fuel filter also extends fuel pump life. Replace the fuel filter in her truck every 30,000 to 40,000 miles to keep the fuel mechanism in optimal condition. Monitor the instructions provided here to adjust the fuel filter ~ above a automobile that go not have actually a flex fuel system.
fuel filter Jan 20, 2010 Fuel filter for silverado and sierra trucks. StepsMake sure you disconnect the negative battery cable before you begin to prevent any kind of sparks igniting fuel vapors.*>Loosen the fuel tank cap to relax the vapor pressure in the fuel tank.
gas-cap Jan 20, 2010 Gas cap. *>You must locoate the fuel pressure regulator. It"s about the dimension of a walnut and also is situated on the chauffeurs side fuel rail because that the 5.3 liter V8.
*>Place the bleed hose of the gauge into a container that will hold the excess fuel. Open up the gauge valve to bleed the system pressure. Surround the fuel push valve through a shop towel together you attach a push gauge to the fuel pressure valve to absorb leaks. Drain any kind of fuel that stays in the gauge right into the container. This can also be done by cranking the engine to relax the pressure in the system.